HS6220 is a single chip 2.4GHz transceiver with an embedded baseband protocol engine, suitable for ultralow power wireless applications. HS6220 is designed for operation in the world wide ISM frequency band at 2.400 - 2.4835GHz. To design a radio system with the HS6220, you simply need an MCU (microcontroller) and a few external passive components. You can operate and configure the HS6220 through a Serial Peripheral Interface (SPI). The register map, which is accessible through the SPI, contains all configuration registers in the HS6220 and is accessible in all operation modes of the chip.
Radio:
• Compatible to HS6200
• Support BLE advertising
• Support Long packet mode (Max 255 byte)
• Common RX and TX interface
• GFSK/FSK modulation
• 1 and 2Mbps air data rate
• 1MHz non-overlapping channel spacing at 1Mbps
• 2MHz non-overlapping channel spacing at 2Mbps
Transmitter:
• Programmable output power: -34 ~ +8dBm
• 17mA at 0dBm output power
Receiver:
• Fast AGC for improved dynamic range
• Integrated channel filters
• 18mA at 2Mbps
• -87dBm sensitivity at 2Mbps
• -90dBm sensitivity at 1Mbps
RF Synthesizer:
• Fully integrated synthesizer
• No external loop filer
• Accepts low cost ±60ppm 16MHz crystal
Protocol engine:
• 1 to 32 bytes dynamic payload length
• Automatic packet handling
• Auto packet transaction handling
• 3 data pipe for 1:3 star networks
Power Management:
• Integrated voltage regulator
• 1.9 to 3.6V supply range
• Idle modes with fast start-up times for advanced power management
• 2µA Power Down mode
• 50uA Sleep mode
Host Interface:
• 3/4-pin hardware SPI
• Max 8Mbps
• 1 separate 32 bytes TX and RX FIFO
• 5V tolerant IO
• Wireless PC peripheral devices
• Mouse, Keyboard
• Remote Control
• Consumer Electronics
• wireless game controller
• Wireless Audio Device
• Toys
• VOIP and wireless headsets
• personal health and recreation facilities
• Smart Home
- BT Version-
- Core-
- Max Speed-
- SRAM-
- Flash-
- PackagesMSOP-10L
- Supply Voltage1.9V - 3.6V
